Skip to content
beginner 20 minMotorAnalog

Control a Servo with a Knob

Turn a potentiometer and a servo follows your hand: the basis of every robot arm.

A potentiometer gives a voltage between 0 and 5 V. analogRead() turns that into a number from 0 to 1023, and map() scales it to a servo angle from 0 to 180 degrees.

Build it

  1. 1

    Wire the potentiometer

    Outer legs to 5V and GND, middle leg to A0.

  2. 2

    Wire the servo

    Brown to GND, red to 5V and orange to pin 9.

  3. 3

    Upload and turn the knob

    The servo horn follows the knob through half a turn.

The code

servo-knob-control.ino
#include <Servo.h>

Servo arm;

void setup() {
  arm.attach(9);
}

void loop() {
  int angle = map(analogRead(A0), 0, 1023, 0, 180);
  arm.write(angle);
  delay(15);
}