Skip to content
beginner 15 minLEDBasics

Blink an LED

The hello-world of electronics: make an LED flash once a second and learn how a digital pin works.

Blinking an LED teaches the three ideas behind every Arduino project: a pin can be an output, HIGH means 5 volts, and delay() pauses the program. Once this works, every other project is a variation of it.

Build it

  1. 1

    Place the LED

    Push the LED into the breadboard. The longer leg is positive (anode).

  2. 2

    Add the resistor

    Connect a 220 ohm resistor from the LED's short leg to the ground rail. The resistor limits the current so the LED does not burn out.

  3. 3

    Wire it to the board

    Run a jumper from pin 13 to the LED's long leg, and another from GND on the board to the ground rail.

  4. 4

    Upload the code

    Open the Arduino IDE, paste the sketch below, choose your board and port, and press Upload. The LED blinks once a second.

The code

blink-an-led.ino
void setup() {
  pinMode(13, OUTPUT);
}

void loop() {
  digitalWrite(13, HIGH);
  delay(500);
  digitalWrite(13, LOW);
  delay(500);
}